Linear 1-Channel Delta-3 Gate Receiver | LIN-GRD

LinearSKU: LIN-GRD

Price:
Sale price$43.49

Estimate shipping

Linear 1-Channel Delta-3 Gate Receiver  | LIN-GRD

Designed for use with automatic gate operators or systems where a remote antenna is needed. The receiver uses the Delta-3 radio format, with 256 possible codes, set by dipswitch. The GRD replaces two different Linear gate receivers, the DRG and the DRG-LV. It is a digital receiver designed for use with automatic gate operators or systems where a remote antenna is needed.

It has a single relay. It replaces two different Linear gate receivers, the DRG and the DRG-LV. The GRD is a digital receiver designed for use with automatic gate operators or systems where a remote antenna is needed. The GRD2 will operate two gates, one gate and an obstacle sensor, or channel one can open the gate and channel two can close the gate.

All of the Delta-3 transmitters, including the two and four-channel transmitters, are compatible with the GRD. The Delta-3 radio format provides 256 different digital codes. The codes are set using the 8-position coding switches 310 MHz frequency in the units. In order to avoid the possibility of duplicating codes in adjacent systems, factory set codes should not be used. The receivers can operate from 16-24 volts AC or 20-30 volts DC and are normally powered by the gate operator. The relay contact(s) are rated at 5 amps @ 32 volts AC/DC NEC Class 2 circuit.

The GRD has an "F" connector for attaching an antenna. The receiver is supplied with a 9-inch local antenna, a three-foot 75-ohm coaxial cable, and a bulkhead connector for mounting the antenna outside the gate operator enclosure.

Includes
  • Whip antenna
  • 3 feet of coaxial cable
  • Bulkhead connector
Features
  • For use with any Delta 3 transmitter
  • Activates one gate operator for access control
  • F-connector, antenna, coaxial cable supplied
  • Single Form ”A” (normally open) relay rated at 30 Volts AC/DC up to 5 Amps
  • 12 and 24 Volt models
  • Same as DRG (DNR00084) and DRG-LV
  • Auto voltage sensing – no jumpers to set
Technical Specifications
  • Power: 12 – 30 VAC or 10.5 – 30 VDC
  • Codes: 256 (set by dip switches)
  • RF frequency: 310 MHz
  • Dimensions: 3.625″ W x 5.25″ H x 1.5″ D
Product Literature

You may also like

Recently viewed